Official US store Free shipping Bundle & Save up to 15%
Lemon

Support

Hi-Hat Controller Sensor on Donner DED-300X

Wiring, module settings, and tips for the Hi-Hat Controller Sensor when used with the Donner DED-300X.

Setup — Hi-Hat Controller Sensor on Donner DED-300X

Use as switch hi-hat

The Hi-Hat Controller Sensor works on the Donner DED-300X as a switch hi-hat: open/closed only.

Continuous Open Closed

Wiring: HI-HAT lead → hi-hat pad + the hi-hat-control lead → hi-hat controller, both on the signal-connection harness

The harness carries a discrete hi-hat-control lead, so the Lemon controller connects. This module's hi-hat channel follows the Alesis/Medeli convention, which reads a Roland-convention controller as open/closed. The pad channel is single-zone.

Hi-hat setup and troubleshooting guide ›

Cable routing

  1. Plug the HI-HAT lead on the module's signal-connection harness into the Lemon hi-hat pad.
  2. Plug the hi-hat-control lead on the harness into the hi-hat controller.
Hi-hat setup and troubleshooting guide ›

Module settings

  1. MENU > SENSITIVITY > select HH > set SEN (drum sensitivity, 01-06), THREH. (trigger threshold, 01-32), XTALK (crosstalk threshold, 01-32), RETR. (repeat trigger, 01-32), and VOL (volume, 00-127).
  2. Press SAVE to store the settings to the current PRESET.
Hi-Hat Controller Sensor also fits 71 other drum modules — see setup

Other compatible drum modules

2Box

Alesis

ATV

Audiofront

Donner

GEWA

Millenium

NUX

Pearl

Roland

Simmons

Yamaha

Support contact

Have a question? Read the FAQ. Need manual help? Email support.