Support
11" Hi-Hat Controller on Alesis Strata Core
Setup — 11" Hi-Hat Controller on Alesis Strata Core
WorksThe 11" Hi-Hat Controller is fully supported on your Alesis Strata Core.
Continuous
Open
Closed
Wiring: 1× TRS (pad) → HH on the snake + the variable hi-hat controller on its dedicated lead
Variable hi-hat is supported — the controller mounts under the cymbal and tracks pedal position continuously, so open, half-open, closed, chick, and splash articulations all play. Calibrate with HH Setup; fine-tune with Pedal Bottom and Pedal Top.
Cable routing
- Connect the hi-hat pad's 1/4" TRS lead to the HH trigger on the snake.
- Mount the variable hi-hat controller under the cymbal on the stand and connect its lead per the assembly guide.
Module settings
- Press the Kit button, then tap Trigger to open Trigger Mode, and tap HH Setup at the top right.
- Loosen the clutch so the cymbal rests on the controller and tap SET; then raise the cymbal to your open height, tighten the clutch, and tap FINISH.
- Open Tweaks for the HH slot to set Bow Sensitivity, Edge Sensitivity, and Threshold.
Tips
- Fine-tune the open-to-closed transition with Pedal Bottom (100–2048) in Advanced — this sets where chick and splash sounds start.
- Pedal Top (2048–4095) sets where the fully open sound plays; adjust Chick Gain, Splash Sensitivity, and Splash Gain for pedal feel.
- Don't set the cymbal too high above the controller — a large gap hurts position tracking.
11" Hi-Hat Controller also fits 69 other drum modules — see setup
Other compatible drum modules
Alesis
Audiofront
Donner
Pearl
Roland
- Roland Octapad SPD-30
- Roland SPD-SX PRO
- Roland TD-02
- Roland TD-07
- Roland TD-1
- Roland TD-4
- Roland TD-6
- Roland TD-8
- Roland TD-9
- Roland TD-10
- Roland TD-11
- Roland TD-12
- Roland TD-15
- Roland TD-17
- Roland TD-20
- Roland TD-25
- Roland TD-27
- Roland TD-30
- Roland TD-50
- Roland TD-50X
- Roland V31
- Roland V51
- Roland V71