Official US store Free shipping Bundle & Save up to 20%
Lemon

Support

Hi-Hat Controller Sensor on NUX DM-7X

Wiring, module settings, and tips for the Hi-Hat Controller Sensor when used with the NUX DM-7X.

Setup — Hi-Hat Controller Sensor on NUX DM-7X

Use as switch hi-hat

The Hi-Hat Controller Sensor works on the NUX DM-7X as a switch hi-hat: open/closed only.

Continuous Open Closed

Wiring: 1× TRS (pad) → Hi-Hat branch + 1× TRS (pedal) → Hi-hat Control branch on the multi-pin trigger snake

Switch-type (open/closed) hi-hat. The DM-7X HIHAT SETTING menu reads the pedal position against HH OPEN VAL / HH CLOSE VAL thresholds and quantizes it to open or closed — the MIDI note map carries open and closed states only, with no half-open entry. Calibrate the pedal range after connecting.

Cable routing

  1. Plug the Lemon hi-hat pad into the HI-HAT branch of the trigger snake.
  2. Plug the hi-hat control pedal into the Hi-hat Control branch of the trigger snake.

Module settings

  1. Press MENU > TRIGGER for the pad's SENSITIVITY, then open MENU > HIHAT SETTING for the pedal.
  2. Set HH VOLUME, and adjust HH OPEN VAL / HH CLOSE VAL so the open and closed points match your pedal's travel.
Hi-Hat Controller Sensor also fits 69 other drum modules — see setup

Other compatible drum modules

2Box

Alesis

ATV

Audiofront

Donner

GEWA

NUX

Pearl

Roland

Simmons

Yamaha

Support contact

Have a question? Read the FAQ. Need manual help? Email support.