Support
Hi-Hat Controller Sensor on Roland TD-8
Setup — Hi-Hat Controller Sensor on Roland TD-8
WorksYes — the Hi-Hat Controller Sensor works as a full hi-hat on the Roland TD-8: variable pedal position.
Continuous
Open
Closed
Wiring: 1× TRS → HI-HAT input on the rear panel + 1× TRS (controller) → HH CTRL input on the rear panel
Continuous hi-hat control. Supports the FD-7 hi-hat control pedal.
Cable routing
- Connect a ¼″ TRS cable from the hi-hat pad to the HI-HAT input on the rear panel.
- Connect a ¼″ TRS cable from the hi-hat controller to the HH CTRL input on the rear panel.
Module settings
- Press [SETUP], then [F1 (TRIG)] — the "TRIGGER BANK" screen appears.
- Press CURSOR to move to the trigger type, then strike the hi-hat pad — the cursor moves to that pad's setting.
- Set the trigger type to PD7 (or PD9) — the TD-8's trigger-type list has no hi-hat values. Pedal position is read from the HH CTRL jack, which takes no type setting of its own.
Tips
- Continuous pedal control provides smooth open-to-closed transitions.
- After turning on the power, do not step on the pedals or strike the pads until the drum kit name appears — depressing the hi-hat control pedal during power-up prevents proper open/close control.