Support
Hi-Hat Controller Sensor on Roland TD-11
Setup — Hi-Hat Controller Sensor on Roland TD-11
WorksYes — the Hi-Hat Controller Sensor works as a full hi-hat on the Roland TD-11: variable pedal position.
Continuous
Open
Closed
Wiring: 1× TRS → HI-HAT connector on the DB-25 cable snake + 1× TRS (controller) → HHC connector on the DB-25 cable snake
Continuous hi-hat control via the cable snake.
Cable routing
- Connect a ¼″ TRS cable from the hi-hat pad to the HI-HAT connector on the DB-25 cable snake.
- Connect a ¼″ TRS cable from the hi-hat controller to the HHC connector on the DB-25 cable snake.
Module settings
- Take your foot off the pedal and make sure the hi-hat is not touching the motion sensor, then power on the module and loosen the clutch screw so the hi-hat rests naturally on the motion sensor unit.
- In the DRUM KIT screen, press [MENU], scroll to the SYSTEM icon, and press [F3] (SYSTEM).
- Use the cursor buttons to select "Pad Settings", press [F3] (ENTER), then press [F1] (TYPE).
- Strike the hi-hat to select the HI-HAT input, then set "Pad Type" to VH-11.
- Press [F2] (BASIC) to fine-tune "Sensitivity" (1-32) and "Threshold" (0-31).
Tips
- Continuous pedal control provides smooth open-to-closed transitions.
- Set the resting gap with the clutch after connecting — a Lemon hi-hat has no offset adjustment screw.