Support
Hi-Hat Controller Sensor on Roland TD-27
Setup — Hi-Hat Controller Sensor on Roland TD-27
WorksYes — the Hi-Hat Controller Sensor works as a full hi-hat on the Roland TD-27: variable pedal position.
Continuous
Open
Closed
Wiring: HI-HAT connector → hi-hat pad + Hi-Hat Control connector → hi-hat controller, both on the DB-25 cable snake
Continuous hi-hat control via the cable snake.
Hi-hat setup and troubleshooting guide ›Cable routing
- Plug the HI-HAT connector on the DB-25 cable snake into the hi-hat pad.
- Plug the Hi-Hat Control connector on the DB-25 cable snake into the hi-hat controller.
Module settings
- With the hi-hat completely separated from the motion sensor unit, power on the TD-27, then loosen the clutch screw and let the hi-hat rest naturally on the motion sensor unit.
- Press [SYSTEM], select "TRIGGER" and press [ENTER], then select "BANK" and press [ENTER] to open the TRIGGER BANK screen.
- Strike the hi-hat (display shows "HH") or use the cursor buttons to select the HI-HAT input.
- Use the dial to set the Trig Type to VH11 (VH10 also works — the Reference Manual's worked example covers both).
- Set the resting gap by raising or lowering the cymbal on the controller until the hi-hat reads open with your foot off the pedal.
Tips
- Continuous pedal control provides smooth open-to-closed transitions.
- Set the resting gap with the clutch after connecting — a Lemon hi-hat has no offset adjustment screw.