Official US store Free shipping Bundle & Save up to 15%
Lemon

Support

Hi-Hat Controller Sensor on Alesis Crimson III

Wiring, module settings, and tips for the Hi-Hat Controller Sensor when used with the Alesis Crimson III.

Setup — Hi-Hat Controller Sensor on Alesis Crimson III

Use as switch hi-hat

The Hi-Hat Controller Sensor works on the Alesis Crimson III as a switch hi-hat: open/closed only.

Continuous Open Closed

Wiring: Hi-Hat connector → hi-hat pad + HH Pedal connector → hi-hat controller, both on the cable snake

The Crimson III supports continuous/variable hi-hat natively — its manual describes pressing the pedal to different positions to change the sound, like an acoustic hi-hat (it ships a continuously-variable control pedal). The Lemon hi-hat controller uses the Roland VH/FD convention, not documented for continuous CV here — so with the Lemon controller, treat hi-hat as open/closed.

Hi-hat setup and troubleshooting guide ›

Cable routing

  1. Plug the Hi-Hat connector on the cable snake into the hi-hat pad.
  2. Plug the HH Pedal connector on the cable snake into the hi-hat controller.
Hi-hat setup and troubleshooting guide ›

Module settings

  1. Go to Kit → Menu → Trigger. Select the Hi-Hat input.
  2. Adjust Head (Bow) Sensi, Threshold, and Pedal Sensi.
  3. Press the F3 (Save) button after editing — otherwise the edited data is lost after powering off.

Tips

  1. No pedal curve options are available — the module uses a fixed pedal response.
  2. Open/closed transitions may feel less nuanced than modules with pedal curve tuning.
  3. If closing the pedal sets off the hi-hat pad, raise VibrateCancel (0–7) — it helps to prevent vibration interference caused by closing the hihat pedal. Set too high, some sounds may be omitted when playing the hihat.
  4. If a single strike sounds twice, increase RetrigCancel (0–15) while repeatedly striking the pad, until re-triggering no longer occurs — too high a value can drop notes in fast playing.
Hi-Hat Controller Sensor also fits 71 other drum modules — see setup

Support contact

Have a question? Read the FAQ. Need manual help? Email support.