Official US store Free shipping Bundle & Save up to 15%
Lemon

Support

Hi-Hat Controller Sensor on Alesis Command

Wiring, module settings, and tips for the Hi-Hat Controller Sensor when used with the Alesis Command.

Setup — Hi-Hat Controller Sensor on Alesis Command

Use as switch hi-hat

The Hi-Hat Controller Sensor works on the Alesis Command as a switch hi-hat: open/closed only.

Continuous Open Closed

Wiring: Hi-Hat connector → hi-hat pad + hi-hat pedal lead → hi-hat controller, both on the cable snake

The Lemon hi-hat controller uses the Roland VH/FD convention, which Alesis doesn't document for continuous CV on this input — so with the Lemon controller, treat hi-hat as open/closed.

Hi-hat setup and troubleshooting guide ›

Cable routing

  1. Plug the Hi-Hat connector on the cable snake into the hi-hat pad.
  2. Plug the hi-hat pedal lead on the cable snake into the hi-hat controller.
Hi-hat setup and troubleshooting guide ›

Module settings

  1. Go to Kit → Menu → Trigger and press Enter. Hit the hi-hat pad to select it.
  2. Adjust Sensitivity and Threshold.
  3. Press Save to keep the changes — otherwise they are lost when you power off the drum module.

Tips

  1. No pedal curve options are available — the module uses a fixed pedal response.
  2. Open/closed transitions may feel less nuanced than modules with pedal curve tuning.
  3. The module's trigger note chart gives every dual-zone input a second edge or rim entry, but none for the hi-hat — play the bow; edge strikes are not a documented zone on this input.
  4. If a single strike sounds twice, check the hi-hat's Trigger page for Retrig Cancel (not all parameters are available for all pads) — it sets the required amount of time between successive hits of the pad to produce the sound for both hits.
  5. If other pads set off the hi-hat, check its Trigger page for Xtalk (not all parameters are available for all pads) — keep it low: if the value is too high, a hit played together with another pad can be silenced as crosstalk.
Hi-Hat Controller Sensor also fits 71 other drum modules — see setup

Support contact

Have a question? Read the FAQ. Need manual help? Email support.