Support
12" 2-Piece Electronic Hi-Hat Cymbals on NUX DM-7X
Setup — 12" 2-Piece Electronic Hi-Hat Cymbals on NUX DM-7X
Use as switch hi-hatThe 12" 2-Piece Electronic Hi-Hat Cymbals works on the NUX DM-7X as a switch hi-hat: open/closed only.
Continuous
Open
Closed
Wiring: Hi-Hat branch → hi-hat pad + Hi-hat Control branch → hi-hat controller, both on the multi-pin trigger snake
Switch-type (open/closed) hi-hat. The DM-7X HIHAT SETTING menu reads the pedal position against HH OPEN VAL / HH CLOSE VAL thresholds and quantizes it to open or closed — the MIDI note map carries open and closed states only, with no half-open entry. Calibrate the pedal range after connecting.
Hi-hat setup and troubleshooting guide ›Cable routing
- Plug the HI-HAT branch of the trigger snake into the Lemon hi-hat pad.
- Plug the Hi-hat Control branch of the trigger snake into the hi-hat controller.
Module settings
- Press MENU > TRIGGER, hit the hi-hat pad to select it, and set its SENSITIVITY; then open MENU > HIHAT SETTING for the pedal.
- Set HH VOLUME (hi-hat level, 0-126), and adjust HH OPEN VAL (70-126) / HH CLOSE VAL (1-60) so the open and closed points match your pedal's travel.
12" 2-Piece Electronic Hi-Hat Cymbals also fits 71 other drum modules — see setup
Other compatible drum modules
Alesis
Audiofront
Donner
Millenium
Pearl
Roland
- Roland Octapad SPD-30
- Roland SPD-SX PRO
- Roland TD-02
- Roland TD-07
- Roland TD-1
- Roland TD-4
- Roland TD-6
- Roland TD-8
- Roland TD-9
- Roland TD-10
- Roland TD-11
- Roland TD-12
- Roland TD-15
- Roland TD-17
- Roland TD-20
- Roland TD-25
- Roland TD-27
- Roland TD-30
- Roland TD-50
- Roland TD-50X
- Roland V31
- Roland V51
- Roland V71