Free Shipping on All Orders
Lemon

Support

14" 2-Piece Electronic Hi-Hat Cymbals on Roland TD-11

Wiring, module settings, and tips for the 14" 2-Piece Electronic Hi-Hat Cymbals when used with the Roland TD-11.

Setup — 14" 2-Piece Electronic Hi-Hat Cymbals on Roland TD-11

Works

The 14" 2-Piece Electronic Hi-Hat Cymbals is fully supported on your Roland TD-11.

Continuous Open Closed

Wiring: 1× TRS → HI-HAT connector on the DB-25 cable snake + 1× TRS → HI-HAT CTRL connector on the DB-25 cable snake

Continuous hi-hat control via the cable snake.

Cable routing

  1. Connect a ¼″ TRS cable from the hi-hat pad to the HI-HAT connector on the DB-25 cable snake.
  2. Connect a ¼″ TRS cable from the hi-hat controller pedal to the HI-HAT CTRL connector on the DB-25 cable snake.

Module settings

  1. Press [SETUP] > Pad Settings.
  2. Navigate to the HI-HAT input.
  3. Set the pad type to match your hi-hat controller.

Tips

  1. Continuous pedal control provides smooth open-to-closed transitions.
  2. Calibrate the hi-hat offset after connecting for accurate pedal response.