Support
T550 12" Snare on Simmons SD1250
Setup — T550 12" Snare on Simmons SD1250
WorksYes — the T550 12" Snare works as a full snare on the Simmons SD1250: head + rim.
Head
Rim
Wiring: The SNARE lead of the multi-pin cable harness → snare pad
The snare input is dual-zone (head + rim): the module's note chart gives SNARE and SNARE RIM SHOT separate MIDI notes.
Snare and tom setup and troubleshooting guide ›Cable routing
- Plug the SNARE lead of the multi-pin cable harness into the snare pad — the leads are marked with the pad each one goes to. The harness ends in a multi-pin connector that plugs into the DB25 Serial Connection Jack on the bottom of the module; apart from the right-side-panel Crash 2 and Tom 4 jacks, every pad reaches the SD1250 through the harness.
Module settings
- In Utility mode, press the Function button under Trigger on the Main Utility screen (Utility → Trigger F1).
- Select the Snare pad via Follow Trigger (strike it) or Current Trigger, then adjust Sensitivity, Threshold, Crosstalk, Retrigger, and Curve.
Tips
- Head triggers from the center piezo, rim from a second piezo mounted under the head.
- On an input that reads head and rim, if the wrong zone plays, tune the module's head/rim settings for this pad's size; values set for a different-size pad may not carry over.
T550 12" Snare also fits 76 other drum modules — see setup
Other compatible drum modules
Alesis
Audiofront
Donner
Lekato
Millenium
Pearl
Roland
- Roland Octapad SPD-30
- Roland SPD-SX
- Roland SPD-SX PRO
- Roland TD-02
- Roland TD-07
- Roland TD-1
- Roland TD-4
- Roland TD-6
- Roland TD-8
- Roland TD-9
- Roland TD-10
- Roland TD-11
- Roland TD-12
- Roland TD-15
- Roland TD-17
- Roland TD-20
- Roland TD-25
- Roland TD-27
- Roland TD-30
- Roland TD-50
- Roland TD-50X
- Roland V31
- Roland V51
- Roland V71