Official US store Free shipping Bundle & Save up to 15%
Lemon

Support

T550 12" Snare on GEWA G5

Wiring, module settings, and tips for the T550 12" Snare when used with the GEWA G5.

Setup — T550 12" Snare on GEWA G5

Works

Yes — the T550 12" Snare works as a full snare on the GEWA G5: head + rim.

Head Rim

Wiring: 1× TRS → SNARE input (1/4" TRS jack)

The snare input supports dual-zone (head + rim) triggering via the center piezo and the rim piezo.

Snare and tom setup and troubleshooting guide ›

Cable routing

  1. Connect a 1/4" TRS cable from the snare pad to the SNARE input on the rear panel.
Snare and tom setup and troubleshooting guide ›

Module settings

  1. Press the [TRIGGER SETTINGS] button to enter Trigger Settings mode.
  2. Turn the dial [5] [<INPUT>] to select the SNARE input (the active input shows as a highlighted letter).
  3. Press [F1] "Settings".
  4. Turn the dial [6] [<ZONE>] to choose the zone (HEAD or RIM).
  5. Turn the dial [5] to Gain and set it with the dial [7] so your hardest stroke reaches full velocity, then do the same for Threshold so light knocks are ignored.

Tips

  1. Head triggers from the center piezo, rim from a second piezo mounted under the head.
  2. Both zones share the one TRS connection (tip = head, ring = rim).
  3. On an input that reads head and rim, if the wrong zone plays, tune the module's head/rim settings for this pad's size; values set for a different-size pad may not carry over.
T550 12" Snare also fits 76 other drum modules — see setup

Support contact

Have a question? Read the FAQ. Need manual help? Email support.