Support
T550 12" Snare on Roland V71
Setup — T550 12" Snare on Roland V71
WorksYes — the T550 12" Snare works as a full snare on the Roland V71: head + rim.
Head
Rim
Wiring: 1× TRS → SNARE input (1/4" TRS jack)
Dual-zone triggering: head (tip) and rim (ring) are read over the single TRS connection and play separate sounds.
Snare and tom setup and troubleshooting guide ›Cable routing
- Connect a 1/4" TRS cable from the snare pad to the SNARE input on the rear panel.
Module settings
- Press the [TRIGGER] button.
- Press the [F1] (BANK) button to open the TRIGGER - BANK screen.
- Select the SNARE input (strike the pad or use the cursor buttons).
- Use the [-] [+] buttons or the dial to set the trigger type to the model that most closely matches your connected pad (the full trigger-type list is in the module's Data List).
- For finer control, press [F3] (BASIC) and adjust Sensitivity on the TRIGGER - BASIC screen.
Tips
- Head triggers from the center piezo, rim from a second piezo mounted under the head.
- Both zones share the one TRS connection (tip = head, ring = rim).
- On an input that reads head and rim, if the wrong zone plays, tune the module's head/rim settings for this pad's size; values set for a different-size pad may not carry over.
T550 12" Snare also fits 76 other drum modules — see setup
Other compatible drum modules
Alesis
Audiofront
Donner
Lekato
Millenium
Pearl
Roland
- Roland Octapad SPD-30
- Roland SPD-SX
- Roland SPD-SX PRO
- Roland TD-02
- Roland TD-07
- Roland TD-1
- Roland TD-4
- Roland TD-6
- Roland TD-8
- Roland TD-9
- Roland TD-10
- Roland TD-11
- Roland TD-12
- Roland TD-15
- Roland TD-17
- Roland TD-20
- Roland TD-25
- Roland TD-27
- Roland TD-30
- Roland TD-50
- Roland TD-50X
- Roland V31
- Roland V51