Free Shipping on All Orders
Lemon

Support

T550 12" Snare on Alesis Nitro Pro

Wiring, module settings, and tips for the T550 12" Snare when used with the Alesis Nitro Pro.

Setup — T550 12" Snare on Alesis Nitro Pro

Works

The T550 12" Snare is fully supported on your Alesis Nitro Pro.

Head Rim

Wiring: 1× TRS → Snare connector on the 25-pin cable snake

The Snare connector on the cable snake supports dual-zone (head + rim) triggering via center piezo and rim switch.

Cable routing

  1. Connect a 1/4" TRS cable from the snare pad to the Snare connector on the 25-pin cable snake.

Module settings

  1. Go to Utility > use Page/Select buttons to navigate: SEN (Sensitivity), THR (Threshold), CUR (Curve).
  2. Select the Snare input and adjust parameters.
  3. R-S (Rim Sensitivity) controls rim zone response.

Tips

  1. Head triggers from the center piezo, rim triggers from the rim switch.
  2. Both zones respond independently on the TRS connection (tip = head, ring = rim).