Support
T550 12" Snare on Roland TD-07
Setup — T550 12" Snare on Roland TD-07
WorksYes — the T550 12" Snare works as a full snare on the Roland TD-07: head + rim.
Head
Rim
Wiring: The snare lead on the dedicated connection cable → snare pad
Dual-zone snare triggering: head (tip) and rim (ring) are read over the one lead. Set the snare pad type to PD105 or PD85 so rim shots and cross-stick register on a Lemon mesh snare.
Snare and tom setup and troubleshooting guide ›Cable routing
- Plug the included dedicated connection cable's snare lead into the Lemon snare pad. Its other end goes to the module's single TRIGGER INPUT connector — each lead is labeled for its pad, and the manual's instruction is simply to "connect the appropriately labeled cable to each pad".
Module settings
- Press [SETUP], select "PAD" with the cursor buttons, and press [ENTER].
- Strike the snare to select its input on the "PAD" screen.
- Select "Type" with the cursor buttons and use the dial to set it to PD105 or PD85 to match your snare.
- Fine-tune "Sens" (1-32) and "Threshold" (0-31) so soft and hard hits register cleanly.
Tips
- Head triggers from the center piezo, rim from a second piezo mounted under the head.
- On an input that reads head and rim, if the wrong zone plays, tune the module's head/rim settings for this pad's size; values set for a different-size pad may not carry over.
T550 12" Snare also fits 76 other drum modules — see setup
Other compatible drum modules
Alesis
Audiofront
Donner
Lekato
Millenium
Pearl
Roland
- Roland Octapad SPD-30
- Roland SPD-SX
- Roland SPD-SX PRO
- Roland TD-02
- Roland TD-1
- Roland TD-4
- Roland TD-6
- Roland TD-8
- Roland TD-9
- Roland TD-10
- Roland TD-11
- Roland TD-12
- Roland TD-15
- Roland TD-17
- Roland TD-20
- Roland TD-25
- Roland TD-27
- Roland TD-30
- Roland TD-50
- Roland TD-50X
- Roland V31
- Roland V51
- Roland V71