Support
12" 2-Piece Electronic Hi-Hat Cymbals on Roland TD-17
Setup — 12" 2-Piece Electronic Hi-Hat Cymbals on Roland TD-17
WorksYes — the 12" 2-Piece Electronic Hi-Hat Cymbals works as a full hi-hat on the Roland TD-17: variable pedal position.
Continuous
Open
Closed
Wiring: The “HH” lead → hi-hat pad + the “HHC” lead → hi-hat controller, both on the dedicated connection cable
Continuous hi-hat control. Supports VH-11 and VH-10 pad types.
Hi-hat setup and troubleshooting guide ›Cable routing
- Plug the lead labeled “HH” on the dedicated connection cable into the hi-hat pad.
- Plug the lead labeled “HHC” into the hi-hat controller. The Setup Guide wires the stock VH-10 the same way: HH plug to its TRIGGER OUT jack, HHC plug to its CONTROL OUT jack.
Module settings
- With your foot off the pedal, power on the TD-17, then loosen the clutch screw so the hi-hat rests naturally on the motion sensor unit.
- Press [SETUP], turn the dial to select "Hi-Hat Settings", then press [ENTER].
- Turn the dial to set Pad Type to VH11 (or VH10).
- Set the resting gap with the clutch while reading the on-screen meter — a Lemon hi-hat has no offset adjustment screw, so raise or lower the cymbal until the meter centres.
Tips
- Continuous pedal control provides smooth open-to-closed transitions.