Support
12" 2-Piece Electronic Hi-Hat Cymbals on GEWA G5
Setup — 12" 2-Piece Electronic Hi-Hat Cymbals on GEWA G5
WorksYes — the 12" 2-Piece Electronic Hi-Hat Cymbals works as a full hi-hat on the GEWA G5: variable pedal position.
Continuous
Open
Closed
Wiring: 1× TRS pad → HI-HAT input + 1× TRS pedal → HHctrl input (1/4" TRS jacks)
GEWA supports third-party hi-hat pads via its trigger presets, and the panel has a dedicated 1/4" TRS hi-hat-control jack (HHctrl; spec "HI-HAT CONTROL: 1× ¼" TRS socket", p.134) that the Lemon bottom-plate controller plugs straight into. An open/close calibration wizard ([F3] HH-CALIB., p.13) sets the pedal range for open, closed and half-open response.
Cable routing
- Connect the hi-hat pad to the HI-HAT input.
- Connect the pedal controller to the HHctrl jack.
Module settings
- Press the [18] [TRIGGER SELECT] button to enter Trigger Settings mode and turn the dial [5] [<INPUT>] to select the HI-HAT input, then press [F1] "Settings" to adjust Threshold, Gain and the other parameters with the dials [5]/[7].
- To calibrate the pedal, press the [TRIGGER SELECT] button, then press [F3] "HH-CALIB.".
- Close the hi-hat to the lowest position and press "NEXT", then open the hi-hat completely and press "FINISH".
Tips
- Run the HH-CALIB. pedal calibration ([F3]) after wiring so the module learns the controller's open and closed end-points.
- After calibration, verify the half-open transition point and adjust the position values to taste.
12" 2-Piece Electronic Hi-Hat Cymbals also fits 69 other drum modules — see setup
Other compatible drum modules
Alesis
Audiofront
Donner
Pearl
Roland
- Roland Octapad SPD-30
- Roland SPD-SX PRO
- Roland TD-02
- Roland TD-07
- Roland TD-1
- Roland TD-4
- Roland TD-6
- Roland TD-8
- Roland TD-9
- Roland TD-10
- Roland TD-11
- Roland TD-12
- Roland TD-15
- Roland TD-17
- Roland TD-20
- Roland TD-25
- Roland TD-27
- Roland TD-30
- Roland TD-50
- Roland TD-50X
- Roland V31
- Roland V51
- Roland V71