Support
12" 2-Piece Electronic Hi-Hat Cymbals on Donner DED-200X
Setup — 12" 2-Piece Electronic Hi-Hat Cymbals on Donner DED-200X
Use as switch hi-hatThe 12" 2-Piece Electronic Hi-Hat Cymbals works on the Donner DED-200X as a switch hi-hat: open/closed only.
Continuous
Open
Closed
Wiring: Hi-hat leads on the signal-connection cable, whose plug screws into the module's parallel-port connector → hi-hat pad + hi-hat controller
Basic open/closed pedal switching. No continuous control. Same as DED-200.
Hi-hat setup and troubleshooting guide ›Cable routing
- Plug the cable snake's hi-hat leads into the hi-hat pad and the hi-hat controller.
Module settings
- In DRUM KIT mode, press MENU, use the encoder or UP/DOWN to select SENSITIVITY, then press ENTER.
- Press UP/DOWN to pick a parameter, tap the hi-hat pad to select it (shown as HH), and turn the encoder to set the value.
- Set SEN (drum sensitivity, 01-06) so your normal stroke registers at full volume.
- Set THREH. (trigger threshold, 01-32) so light knocks don't trigger the pad.
- Raise XTALK (crosstalk threshold, 01-32) if a neighbouring pad false-triggers this one, and RETR. (repeat trigger, 01-32) if you get double triggers.
- Set VOL (volume, 00-127) to balance the pad against the rest of the kit.
- Press SAVE to store the settings.
Tips
- The hi-hat pedal is switch-type only — open and closed states.
- No continuous pedal control or half-open articulations.
12" 2-Piece Electronic Hi-Hat Cymbals also fits 71 other drum modules — see setup
Other compatible drum modules
Alesis
Audiofront
Donner
Millenium
Pearl
Roland
- Roland Octapad SPD-30
- Roland SPD-SX PRO
- Roland TD-02
- Roland TD-07
- Roland TD-1
- Roland TD-4
- Roland TD-6
- Roland TD-8
- Roland TD-9
- Roland TD-10
- Roland TD-11
- Roland TD-12
- Roland TD-15
- Roland TD-17
- Roland TD-20
- Roland TD-25
- Roland TD-27
- Roland TD-30
- Roland TD-50
- Roland TD-50X
- Roland V31
- Roland V51
- Roland V71