Free Shipping on All Orders
Lemon

Support

12" 2-Piece Electronic Hi-Hat Cymbals on Roland V71

Wiring, module settings, and tips for the 12" 2-Piece Electronic Hi-Hat Cymbals when used with the Roland V71.

Setup — 12" 2-Piece Electronic Hi-Hat Cymbals on Roland V71

Works

The 12" 2-Piece Electronic Hi-Hat Cymbals is fully supported on your Roland V71.

Continuous Open Closed

Wiring: 1× TRS → HI-HAT input on the rear panel + 1× TRS → HI-HAT CTRL input on the rear panel

Continuous hi-hat control with granular pedal curve adjustment.

Cable routing

  1. Connect a ¼″ TRS cable from the hi-hat pad to the HI-HAT input on the rear panel.
  2. Connect a ¼″ TRS cable from the hi-hat controller pedal to the HI-HAT CTRL input on the rear panel.

Module settings

  1. Press [TRIGGER] > [F1] BANK.
  2. Navigate to the HI-HAT input.
  3. Set the pad type to VH-10 or VH-11.

Tips

  1. Calibrate the VH offset: loosen the clutch, let the hi-hat rest on the motion sensor, and adjust the offset screw until the on-screen indicator is centered.
  2. Pedal curve is adjustable for fine control over the open-to-closed gradient.