Support
12" 2-Piece Electronic Hi-Hat Cymbals on Simmons SD1200
Setup — 12" 2-Piece Electronic Hi-Hat Cymbals on Simmons SD1200
Use as switch hi-hatThe 12" 2-Piece Electronic Hi-Hat Cymbals works on the Simmons SD1200 as a switch hi-hat: open/closed only.
Continuous
Open
Closed
Wiring: HH lead → hi-hat pad + HH PEDAL lead → hi-hat controller, both on the multi-pin cable harness
The Lemon hi-hat pad and controller connect through the multi-pin cable harness and deliver open and closed hi-hat.
Hi-hat setup and troubleshooting guide ›Cable routing
- Plug the HH lead of the multi-pin cable harness into the hi-hat pad and the HH PEDAL lead into the hi-hat controller.
Module settings
- With your foot off the pedal, set the resting gap at the clutch: loosen the clutch, raise the top cymbal on the controller until the released sound is as open as it gets, then tighten it — the clutch is the only control.
- Press the pedal to confirm it still reaches the closed sound; if it doesn't, lower the cymbal slightly and set the gap again.
- Utility > Trigger > select Hi-Hat > adjust Sensitivity, Threshold, Curve, Retrigger, Crosstalk.
Tips
- Set the resting gap at the clutch before judging the hi-hat — with the cymbal sitting too low on the controller, the released position can sound half-open rather than fully open.
12" 2-Piece Electronic Hi-Hat Cymbals also fits 71 other drum modules — see setup
Other compatible drum modules
Alesis
Audiofront
Donner
Millenium
Pearl
Roland
- Roland Octapad SPD-30
- Roland SPD-SX PRO
- Roland TD-02
- Roland TD-07
- Roland TD-1
- Roland TD-4
- Roland TD-6
- Roland TD-8
- Roland TD-9
- Roland TD-10
- Roland TD-11
- Roland TD-12
- Roland TD-15
- Roland TD-17
- Roland TD-20
- Roland TD-25
- Roland TD-27
- Roland TD-30
- Roland TD-50
- Roland TD-50X
- Roland V31
- Roland V51
- Roland V71