Support
T950 13"x5" Snare Drum on Donner DED-200X
Setup — T950 13"x5" Snare Drum on Donner DED-200X
WorksYes — the T950 13"x5" Snare Drum works as a full snare on the Donner DED-200X: head + rim.
Head
Rim
Wiring: Snare connector on the cable harness → snare pad
The DED-200X shares the DED-200 electronics; the snare channel is dual-zone — the head and the rim/sidestick trigger as separate MIDI notes. Pads connect through a labeled multi-pin harness that plugs into the module's parallel trigger port.
Snare and tom setup and troubleshooting guide ›Cable routing
- Plug the Snare connector on the cable harness into the snare pad.
Module settings
- In DRUM KIT mode, press MENU, select SENSITIVITY, and press ENTER.
- Tap the snare pad to select it (shown as SN), press UP/DOWN to pick a parameter, and turn the encoder: SEN (drum sensitivity 01-06), THREH. (trigger threshold 01-32), XTALK (crosstalk 01-32), RETR. (repeat trigger 01-32), VOL (volume 00-127).
- Press SAVE to store the settings.
Tips
- Snare MIDI notes: head (S1) = 38, rim/sidestick (S2) = 37.
- MENU > MIDI NOTE lets you remap any zone's MIDI value if you use external software.
- On an input that reads head and rim, if the wrong zone plays, tune the module's head/rim settings for this pad's size; values set for a different-size pad may not carry over.
T950 13"x5" Snare Drum also fits 76 other drum modules — see setup
Other compatible drum modules
Alesis
Audiofront
Donner
Lekato
Millenium
Pearl
Roland
- Roland Octapad SPD-30
- Roland SPD-SX
- Roland SPD-SX PRO
- Roland TD-02
- Roland TD-07
- Roland TD-1
- Roland TD-4
- Roland TD-6
- Roland TD-8
- Roland TD-9
- Roland TD-10
- Roland TD-11
- Roland TD-12
- Roland TD-15
- Roland TD-17
- Roland TD-20
- Roland TD-25
- Roland TD-27
- Roland TD-30
- Roland TD-50
- Roland TD-50X
- Roland V31
- Roland V51
- Roland V71