Support
T950 13"x5" Snare Drum on Roland TD-6
Setup — T950 13"x5" Snare Drum on Roland TD-6
WorksYes — the T950 13"x5" Snare Drum works as a full snare on the Roland TD-6: head + rim.
Head
Rim
Wiring: 1× TRS → SNARE input (TRIGGER INPUT 2) on the rear panel
Dual-zone snare triggering: head (tip) and rim (ring) are read via the single TRS connection on the SNARE input.
Snare and tom setup and troubleshooting guide ›Cable routing
- Connect a 1/4" TRS cable from the snare pad to the SNARE input (TRIGGER INPUT 2) on the rear panel.
Module settings
- Hold [SHIFT] and press [EDIT (SETUP)] to enter setup mode, then select TRIG BASIC.
- Strike the snare so the display shows the SNR input.
- Set the Trigger Type to PD80R or PD120 (the settings for PD-80R / PD-120 mesh dual-zone pads) — these are the trigger types optimized for separate head + rim sensing on the SNARE input.
Tips
- Head triggers from the center piezo, rim from a second piezo mounted under the head.
- Both zones share the one TRS connection (tip = head, ring = rim).
- The SNARE input is the only TD-6 input that fully supports the mesh-style rim signal used by PD-80R / PD-120 pads.
- On an input that reads head and rim, if the wrong zone plays, tune the module's head/rim settings for this pad's size; values set for a different-size pad may not carry over.
T950 13"x5" Snare Drum also fits 76 other drum modules — see setup
Other compatible drum modules
Alesis
Audiofront
Donner
Lekato
Millenium
Pearl
Roland
- Roland Octapad SPD-30
- Roland SPD-SX
- Roland SPD-SX PRO
- Roland TD-02
- Roland TD-07
- Roland TD-1
- Roland TD-4
- Roland TD-8
- Roland TD-9
- Roland TD-10
- Roland TD-11
- Roland TD-12
- Roland TD-15
- Roland TD-17
- Roland TD-20
- Roland TD-25
- Roland TD-27
- Roland TD-30
- Roland TD-50
- Roland TD-50X
- Roland V31
- Roland V51
- Roland V71