Support
T950 13"x5" Snare Drum on Roland TD-20
Setup — T950 13"x5" Snare Drum on Roland TD-20
WorksYes — the T950 13"x5" Snare Drum works as a full snare on the Roland TD-20: head + rim.
Head
Rim
Wiring: 1× TRS → SNARE input (1/4" TRS jack)
Dual-zone triggering: head (tip) and rim (ring) are read over the single TRS connection and play separate sounds.
Snare and tom setup and troubleshooting guide ›Cable routing
- Connect a 1/4" TRS cable from the snare pad to the SNARE input on the rear panel.
Module settings
- Press [TRIGGER], then [F1 (BANK)] to open the TRIGGER BANK screen.
- Strike the snare to select the SNARE input (or use [TRIG SELECT]).
- Use [+/-] or the [VALUE] dial to set Trig Type to PD125 or PD105.
- Press [F2 (BASIC)] and set Sensitivity and Threshold for the snare.
Tips
- Head triggers from the center piezo, rim from a second piezo mounted under the head.
- Both zones share the one TRS connection (tip = head, ring = rim).
- On an input that reads head and rim, if the wrong zone plays, tune the module's head/rim settings for this pad's size; values set for a different-size pad may not carry over.
T950 13"x5" Snare Drum also fits 76 other drum modules — see setup
Other compatible drum modules
Alesis
Audiofront
Donner
Lekato
Millenium
Pearl
Roland
- Roland Octapad SPD-30
- Roland SPD-SX
- Roland SPD-SX PRO
- Roland TD-02
- Roland TD-07
- Roland TD-1
- Roland TD-4
- Roland TD-6
- Roland TD-8
- Roland TD-9
- Roland TD-10
- Roland TD-11
- Roland TD-12
- Roland TD-15
- Roland TD-17
- Roland TD-25
- Roland TD-27
- Roland TD-30
- Roland TD-50
- Roland TD-50X
- Roland V31
- Roland V51
- Roland V71