Support
14" 2-Piece Electronic Hi-Hat Cymbals on Donner DED-400
Setup — 14" 2-Piece Electronic Hi-Hat Cymbals on Donner DED-400
Use as switch hi-hatThe 14" 2-Piece Electronic Hi-Hat Cymbals works on the Donner DED-400 as a switch hi-hat: open/closed only.
Continuous
Open
Closed
Wiring: 1× TRS pad → HI-HAT lead, with the pedal on its own separate lead of the signal-connection harness (the panel distinguishes HI-HAT from HH-CTRL, p.9)
Switch-type hi-hat — the manual documents three discrete states (p.10), not continuous pedal travel.
Cable routing
- Connect the hi-hat pad to the HI-HAT lead on the module's signal-connection harness; the pedal runs on its own separate lead (p.9).
- Note: HH-CTRL on the DED-400 is a top-panel button, not a jack — don't look for it as a connector.
Module settings
- Press the MENU button, use +/- to select 2-PAD SET, and press OK to enter the pad parameter interface.
- Tap the hi-hat pad to select it, then press + / - to choose a parameter and turn the encoder to set the value (press OK to confirm).
- Set Pad Sen (surface sensitivity, 1-6), HH.L (stomp cymbal sensitivity, 1-3), HH.S (stomp cymbal speed, 1-3), Threshold (trigger threshold, 1-32), and Volume (0-127).
- Press SAVE to store the settings.
Tips
- HH.L (stomp cymbal sensitivity) and HH.S (stomp cymbal speed) tune the pedal response (p.11).
14" 2-Piece Electronic Hi-Hat Cymbals also fits 69 other drum modules — see setup
Other compatible drum modules
Alesis
Audiofront
Donner
Pearl
Roland
- Roland Octapad SPD-30
- Roland SPD-SX PRO
- Roland TD-02
- Roland TD-07
- Roland TD-1
- Roland TD-4
- Roland TD-6
- Roland TD-8
- Roland TD-9
- Roland TD-10
- Roland TD-11
- Roland TD-12
- Roland TD-15
- Roland TD-17
- Roland TD-20
- Roland TD-25
- Roland TD-27
- Roland TD-30
- Roland TD-50
- Roland TD-50X
- Roland V31
- Roland V51
- Roland V71