Official US store Free shipping Bundle & Save up to 15%
Lemon

Support

14" 2-Piece Electronic Hi-Hat Cymbals on Simmons SD1500

Wiring, module settings, and tips for the 14" 2-Piece Electronic Hi-Hat Cymbals when used with the Simmons SD1500.

Setup — 14" 2-Piece Electronic Hi-Hat Cymbals on Simmons SD1500

Use as switch hi-hat

The 14" 2-Piece Electronic Hi-Hat Cymbals works on the Simmons SD1500 as a switch hi-hat: open/closed only.

Continuous Open Closed

Wiring: "To Hi-Hat" branch → hi-hat pad + "To Hi-Hat Control" branch → hi-hat controller, both on the multi-pin cable harness

The Lemon hi-hat pad and controller connect through the multi-pin cable harness and deliver open and closed hi-hat.

Hi-hat setup and troubleshooting guide ›

Cable routing

  1. Plug the "To Hi-Hat" branch of the multi-pin cable harness into the hi-hat pad.
  2. Plug the "To Hi-Hat Control" branch into the hi-hat controller — the manual notes this is the plug labeled "Hi-Hat Control".
Hi-hat setup and troubleshooting guide ›

Module settings

  1. With your foot off the pedal, set the resting gap at the clutch: loosen the clutch, raise the top cymbal on the controller until the released sound is as open as it gets, then tighten it — the clutch is the only control.
  2. Press the pedal to confirm it still reaches the closed sound; if it doesn't, lower the cymbal slightly and set the gap again.
  3. Press [UTILITY], then [MENU] to open Trigger Setup.
  4. Select the Hi-Hat input (strike the pad or use its Pad Select button).
  5. Step with [PAGE -/+] and adjust Sensitive, Thresh, Curve, Retrig-C, X-Talk.

Tips

  1. Set the resting gap at the clutch before judging the hi-hat — with the cymbal sitting too low on the controller, the released position can sound half-open rather than fully open.
14" 2-Piece Electronic Hi-Hat Cymbals also fits 71 other drum modules — see setup

Support contact

Have a question? Read the FAQ. Need manual help? Email support.