Support
14" 2-Piece Electronic Hi-Hat Cymbals on GEWA G9
Setup — 14" 2-Piece Electronic Hi-Hat Cymbals on GEWA G9
WorksYes — the 14" 2-Piece Electronic Hi-Hat Cymbals works as a full hi-hat on the GEWA G9: variable pedal position.
Continuous
Open
Closed
Wiring: 1× TRS pad → HI-HAT input + 1× TRS pedal → HHCTRL input (1/4" TRS jacks)
GEWA supports third-party hi-hat pads via its trigger presets, and the panel has a dedicated 1/4" TRS hi-hat-control jack (HHCTRL) that the Lemon bottom-plate controller plugs straight into. A Hi-Hat Calibration wizard ([Calibrate...], p.94) sets the Low/High pedal positions for open, closed and half-open response.
Cable routing
- Connect the hi-hat pad to the HI-HAT input.
- Connect the pedal controller to the HHCTRL jack.
Module settings
- Tap the [Advanced] button and open Trigger Settings mode.
- In the Input Channels list, select the Hi-Hat input channel, then tap the Hi-Hat Pedal icon in module 2.
- In the Trigger Settings function set (Module 3), set the pedal response with the Low Position, High Position, Chick Sensitivity and Splash Sensitivity parameters.
- To set Low/High Position automatically, tap the [Calibrate...] field and follow the Hi-Hat Calibration wizard.
Tips
- Run the Hi-Hat Calibration wizard ([Calibrate...]) after wiring so the module learns the controller's open and closed end-points.
- After calibration, verify the half-open transition point and adjust the position values to taste.
14" 2-Piece Electronic Hi-Hat Cymbals also fits 69 other drum modules — see setup
Other compatible drum modules
Alesis
Audiofront
Donner
Pearl
Roland
- Roland Octapad SPD-30
- Roland SPD-SX PRO
- Roland TD-02
- Roland TD-07
- Roland TD-1
- Roland TD-4
- Roland TD-6
- Roland TD-8
- Roland TD-9
- Roland TD-10
- Roland TD-11
- Roland TD-12
- Roland TD-15
- Roland TD-17
- Roland TD-20
- Roland TD-25
- Roland TD-27
- Roland TD-30
- Roland TD-50
- Roland TD-50X
- Roland V31
- Roland V51
- Roland V71