Support
14" 2-Piece Electronic Hi-Hat Cymbals on 2Box DrumIt 3
Setup — 14" 2-Piece Electronic Hi-Hat Cymbals on 2Box DrumIt 3
WorksYes — the 14" 2-Piece Electronic Hi-Hat Cymbals works as a full hi-hat on the 2Box DrumIt 3: variable pedal position.
Continuous
Open
Closed
Wiring: 1× TRS pad → HIHAT A input + 1× TRS pedal → HIHAT B input (1/4" TRS jacks)
Continuous hi-hat. The DrumIt Three's hi-hat channel calibrates the connected controller through its UNIT-HCAL page — set HTYP to DEF, trim the RAW value to match the pad, and run the CALIB routine to capture the pedal's closed and open end-points.
Cable routing
- Connect the hi-hat pad to the HIHAT A input.
- Connect the pedal controller to the HIHAT B jack.
Module settings
- Select the hi-hat channel (hit the pad or use the CHANNEL buttons) and open the UNIT-HCAL page (shown only when the hi-hat channel is selected).
- Set HTYP to the hi-hat type: DEF (all popular types), 2BOXHH, or ALEHH.
- Set the RAW value to match the pad using the recessed HH Cal screw on the back panel (Roland-style pads: 800-850).
- Run CALIB: press the leftmost DATA button, close the pedal, press it again, open the pedal, then press once more to exit (display reads 'done').
- On the UNIT-TRIG page set GAIN, THRES, and CURVE for the hi-hat channel.
- On the UNIT-HSET page set SENS (pedal sensitivity) and CURVE (dynamic response); fine-tune PFACT/POFF on UNIT-HCAL for foot chick/splash if needed.
Tips
- Calibrate the hi-hat pedal range (open/closed end-points) in the module settings so the response tracks the full pedal travel.
14" 2-Piece Electronic Hi-Hat Cymbals also fits 69 other drum modules — see setup
Other compatible drum modules
2Box
Alesis
Audiofront
Donner
Pearl
Roland
- Roland Octapad SPD-30
- Roland SPD-SX PRO
- Roland TD-02
- Roland TD-07
- Roland TD-1
- Roland TD-4
- Roland TD-6
- Roland TD-8
- Roland TD-9
- Roland TD-10
- Roland TD-11
- Roland TD-12
- Roland TD-15
- Roland TD-17
- Roland TD-20
- Roland TD-25
- Roland TD-27
- Roland TD-30
- Roland TD-50
- Roland TD-50X
- Roland V31
- Roland V51
- Roland V71