Support

14" 2-Piece Electronic Hi-Hat Cymbals on Alesis Nitro

Wiring, module settings, and tips for the 14" 2-Piece Electronic Hi-Hat Cymbals when used with the Alesis Nitro.

The 14" 2-Piece Electronic Hi-Hat Cymbals works on the Alesis Nitro as a switch hi-hat: open/closed only.

Continuous Open Closed

Wiring: 1× TRS (pad) → Hi-Hat connector on the 25-pin cable snake + 1× TRS (pedal) → the hi-hat pedal lead on the cable snake

The HH Pedal input is not documented as Roland VH/FD compatible, and there is no pedal curve or half-open voice — treat as open/closed.

Connect a ¼″ TRS cable from the hi-hat pad to the Hi-Hat connector on the 25-pin cable snake.
Connect a ¼″ TRS cable from the hi-hat pedal controller to the hi-hat pedal lead on the cable snake.

No pedal curve options are available — the module uses a fixed pedal response.
Hi-hat voice selection is limited to H-C 001–007.
Open/closed transitions may feel less nuanced than modules with pedal curve tuning.

14" 2-Piece Electronic Hi-Hat Cymbals also fits 69 other drum modules — see setup

Setup — 14" 2-Piece Electronic Hi-Hat Cymbals on Alesis Nitro