Support
14" 2-Piece Electronic Hi-Hat Cymbals on Alesis Strata Prime
Setup — 14" 2-Piece Electronic Hi-Hat Cymbals on Alesis Strata Prime
WorksThe 14" 2-Piece Electronic Hi-Hat Cymbals is fully supported on your Alesis Strata Prime.
Continuous
Open
Closed
Wiring: 1× TRS (pad) → Hi-Hat trigger input + the hi-hat controller on the stand
Variable hi-hat is fully supported — the magnetic controller mounts under the cymbal and tracks the pedal's relative position continuously, so open, half-open, closed, chick, and splash articulations all play. The Hi-Hat slot also reads Bow, Edge, and Bell zones.
Cable routing
- Connect a 1/4" TRS cable from the hi-hat pad to the Hi-Hat trigger input on the rear panel.
- Mount the hi-hat controller under the cymbal on the hi-hat stand so it tracks the pedal travel.
Module settings
- Open Trigger Edit Mode, tap HH Setup, and run the calibration: loosen the clutch, let the cymbal rest, tap SET, then raise to playing height and press FINISH.
- Fine-tune Pedal Bottom so open sounds transition to closed at the position you want, and where chick/splash start.
- Adjust Chick Gain, Splash Sensitivity, and Splash Gain for the foot-technique response you prefer.
Tips
- Pedal Bottom is the key playability control — higher makes chick/splash more sensitive, lower makes open/closed patterns more realistic.
- Pedal Top generally needs no change after calibration; it sets where the fully open sound plays.
- Re-run HH Setup if you change the cymbal height so the variable response tracks the full pedal travel.
- Do not set the cymbal too high above the controller piston, or position tracking suffers.
14" 2-Piece Electronic Hi-Hat Cymbals also fits 69 other drum modules — see setup
Other compatible drum modules
Alesis
Audiofront
Donner
Pearl
Roland
- Roland Octapad SPD-30
- Roland SPD-SX PRO
- Roland TD-02
- Roland TD-07
- Roland TD-1
- Roland TD-4
- Roland TD-6
- Roland TD-8
- Roland TD-9
- Roland TD-10
- Roland TD-11
- Roland TD-12
- Roland TD-15
- Roland TD-17
- Roland TD-20
- Roland TD-25
- Roland TD-27
- Roland TD-30
- Roland TD-50
- Roland TD-50X
- Roland V31
- Roland V51
- Roland V71