Free Shipping on All Orders
Lemon

Support

T550 12" Kick on Alesis Nitro Pro

Wiring, module settings, and tips for the T550 12" Kick when used with the Alesis Nitro Pro.

Setup — T550 12" Kick on Alesis Nitro Pro

Works

The T550 12" Kick is fully supported on your Alesis Nitro Pro.

Trigger

Wiring: 1× TS or TRS → Kick connector on the 25-pin cable snake

Single-zone kick trigger via the cable snake. Only the head zone is active.

Cable routing

  1. Connect a 1/4" TS or TRS cable from the kick pad to the Kick connector on the 25-pin cable snake.

Module settings

  1. Go to Utility > use Page/Select buttons to navigate: SEN (Sensitivity), THR (Threshold), CUR (Curve).
  2. Select the Kick input and adjust parameters.

Tips

  1. Single-zone operation — only the head zone is active.
  2. A TS cable is sufficient for single-zone kick pads; TRS also works (ring is unused).