Support
Setup for your 2Box DrumIt 3
Yes — Lemon pads cover snare, toms, kick, cymbals, ride, and hi-hat on the 2Box DrumIt 3.
- Snare 2-zone
- Toms 2-zone
- Kick 1-zone
- Crash 2-zone
- Ride 3-zone
- Hi-hat Continuous
Module snapshot
- Brand
- 2Box
- Model
- DrumIt 3
- Also known as
- DrumIt 3, DrumIt Three
Setup details by role
Snare pad 2-zone 1× TRS → SNARE input (1/4" TRS jack)
The snare input supports dual-zone (head + rim) triggering via center piezo and rim switch.
Tom pad 2-zone 1× TRS per tom → TOM1, TOM2, TOM3 inputs (1/4" TRS jacks)
The tom inputs support dual-zone (head + rim) triggering via center piezo and rim switch.
Kick pad Works 1× TS or TRS → KICK input (1/4" TRS jack)
Single-zone kick trigger. Only the head zone is active.
2-zone crash 2-zone 1× TRS → cymbal input (1/4" TRS jack)
Full dual-zone cymbal support with bow and edge.
3-zone ride 3-zone 2× TRS: bow/edge → CYMB A jack, bow/bell → the paired CYMB B jack (e.g. CYMB 3A + CYMB 3B)
Full 3-zone ride (bow, bell, edge). The DrumIt Three has no dedicated ride input — assign the ride to any CYMB channel. Each CYMB channel exposes paired A/B jacks built for cymbals that use two stereo cables: the A jack reads bow (tip) + edge (ring) and the B jack reads the bell. The Lemon ride's two cables map straight across.
Hi-hat Continuous 1× TRS pad → HIHAT A input + 1× TRS pedal → HIHAT B input (1/4" TRS jacks)
Continuous hi-hat. The DrumIt Three's hi-hat channel calibrates the connected controller through its UNIT-HCAL page — set HTYP to DEF, trim the RAW value to match the pad, and run the CALIB routine to capture the pedal's closed and open end-points.
