Support

9" Dual-Zone Splash on Roland V51

Wiring, module settings, and tips for the 9" Dual-Zone Splash when used with the Roland V51.

Yes — the 9" Dual-Zone Splash works as a full 2-zone crash on the Roland V51: bow + edge.

Bow Edge

Wiring: 1× TRS → CRASH1 connector on the DB-25 cable snake, or CRASH2 / AUX1/TOM4 / AUX2 / AUX3 direct jack on the rear panel

Dual-zone crash triggering: bow (tip) and edge (ring) respond independently via the single TRS connection. Choke works by grabbing the cymbal edge. The V-51 supports Roland CY-series 2-zone cymbals.

Cable routing

Connect a ¼″ TRS cable from the cymbal to the CRASH1 connector on the DB-25 cable snake.
For additional cymbals, connect to the CRASH2, AUX1/TOM4, AUX2, or AUX3 input on the rear panel.

Module settings

Press the [SETUP] button.
Use the cursor buttons to select "TRIGGER", then press [ENTER].
Press the [F1] (BANK) button to open the TRIGGER - BANK screen.
Select the CRASH1, CRASH2, or AUX input (strike the pad or use the cursor buttons).
Use the [-] [+] buttons or the dial to set the trigger type to the model that most closely matches your connected pad (the full trigger-type list is in the module's Data List).
For finer control, press [F3] (BASIC) and adjust the pad's Sensitivity.

Tips

Bow and edge zones respond independently.
Choke works by grabbing the cymbal edge.
The DIGITAL TRIGGER IN (USB) jacks are for Roland digital pads only.

9" Dual-Zone Splash also fits 73 other drum modules — see setup

Other compatible drum modules

2Box

Alesis

ATV

Audiofront

Audiofront eDRUMin

Donner

Efnote

GEWA

NUX

Pearl

Pearl Mimic Pro

Roland

Simmons

Yamaha

Have a question? Read the FAQ. Need manual help? Email support.