Support
20" Triple-Zone Crash/Ride on Roland V51
Setup — 20" Triple-Zone Crash/Ride on Roland V51
WorksYes — the 20" Triple-Zone Crash/Ride works as a full 3-zone ride on the Roland V51: bow + bell + edge.
Bell
Bow
Edge
Wiring: RD + RDB connectors on the dedicated connection cable → Ride 1 + Ride 2
Full 3-zone ride — the manual instructs connecting a ride that supports three-way triggering to the RD and RDB connectors of the dedicated connection cable.
Ride setup and troubleshooting guide ›Cable routing
- Plug the RD (ride) connector on the connection cable into the cymbal's Ride 1 output (bow/edge).
- Plug the RDB (ride bell) connector on the connection cable into the cymbal's Ride 2 output (bell).
Module settings
- Press the [SETUP] button.
- Use the cursor buttons to select "TRIGGER", then press [ENTER].
- Press the [F1] (BANK) button to open the TRIGGER - BANK screen.
- Select the RIDE input (strike the pad or use the cursor buttons).
- Use the [-] [+] buttons or the dial to set the trigger type to CY-14R-T (the manual's three-way ride example).
- Both the RD and RDB leads must be connected for bow, bell, and edge.
Tips
- Both leads are required for full 3-zone operation (bell, bow, edge).
- If only one lead is connected, the ride will function as 2-zone only.
- If the edge and bell sounds come out swapped, follow the bell and edge section of the ride setup guide.
20" Triple-Zone Crash/Ride also fits 76 other drum modules — see setup
Other compatible drum modules
Alesis
Audiofront
Donner
Lekato
Millenium
Pearl
Roland
- Roland Octapad SPD-30
- Roland SPD-SX
- Roland SPD-SX PRO
- Roland TD-02
- Roland TD-07
- Roland TD-1
- Roland TD-4
- Roland TD-6
- Roland TD-8
- Roland TD-9
- Roland TD-10
- Roland TD-11
- Roland TD-12
- Roland TD-15
- Roland TD-17
- Roland TD-20
- Roland TD-25
- Roland TD-27
- Roland TD-30
- Roland TD-50
- Roland TD-50X
- Roland V31
- Roland V71