Support

9" Dual-Zone Splash on Donner DED-200X

Wiring, module settings, and tips for the 9" Dual-Zone Splash when used with the Donner DED-200X.

Yes — the 9" Dual-Zone Splash works as a full 2-zone crash on the Donner DED-200X: bow + edge.

Bow Edge

Wiring: 1× TRS → Crash connector (via cable snake) or Crash 2 jack (1/4" TRS, rear panel)

Same specifications as the DED-200. Connect to Crash connector on the cable snake or Crash 2 jack on rear panel.

Connect to the Crash connector on the cable snake, or use the Crash 2 jack (1/4" TRS) on the rear panel.
The DED-200X shares the same cable snake and rear panel layout as the DED-200.

In DRUM KIT mode, press MENU, use the encoder or UP/DOWN to select SENSITIVITY, then press ENTER.
Press UP/DOWN to pick a parameter, tap the crash pad to select it (shown as CR), and turn the encoder to set the value.
Set SEN (drum sensitivity, 01-06) so your normal stroke registers at full volume.
Set THREH. (trigger threshold, 01-32) so light knocks don't trigger the pad.
Raise XTALK (crosstalk threshold, 01-32) if a neighbouring pad false-triggers this one, and RETR. (repeat trigger, 01-32) if you get double triggers.
Set VOL (volume, 00-127) to balance the pad against the rest of the kit.
Press SAVE to store the settings.

9" Dual-Zone Splash also fits 73 other drum modules — see setup

Other compatible drum modules

Have a question? Read the FAQ. Need manual help? Email support.