Support

11" Dual-Zone Splash/Crash on Roland V51

Wiring, module settings, and tips for the 11" Dual-Zone Splash/Crash when used with the Roland V51.

The 11" Dual-Zone Splash/Crash is fully supported on your Roland V51.

Bow Edge

Wiring: 1× TRS → CRASH1 connector on the DB-25 cable snake, or CRASH2 / AUX1/TOM4 / AUX2 / AUX3 direct jack on the rear panel

Dual-zone crash triggering: bow (tip) and edge (ring) respond independently via the single TRS connection. Choke works by grabbing the cymbal edge. The V-51 supports Roland CY-series 2-zone cymbals.

Cable routing

Connect a ¼″ TRS cable from the cymbal to the CRASH1 connector on the DB-25 cable snake.
For additional cymbals, connect to the CRASH2, AUX1/TOM4, AUX2, or AUX3 input on the rear panel.

Module settings

Press [TRIGGER] > [F1] BANK.
Navigate to the CRASH1, CRASH2, or AUX input.
Set the trigger type to CY-12C or CY-14C depending on your cymbal size.

Tips

Bow and edge zones respond independently.
Choke works by grabbing the cymbal edge.
The DIGITAL TRIGGER IN (USB) jacks are for Roland digital pads only.