Support
15" Triple-Zone Crash/Ride on Roland TD-30
Setup — 15" Triple-Zone Crash/Ride on Roland TD-30
WorksYes — the 15" Triple-Zone Crash/Ride works as a full 3-zone ride on the Roland TD-30: bow + bell + edge. It needs a one-time cymbal rewire first.
Bell
Bow
Edge
Wiring: Rewire the cymbal, then 2× TRS → Input 10 RIDE (Ride 2) + Input 11 EDGE (Ride 1) on the rear panel
All three zones (bow, bell, edge) using the TD-30's 3-Way Trigger, after a one-time, reversible jumper move inside the cymbal (~10 min). 3Way Trigger must be set to ON.
Ride setup and troubleshooting guide ›Cable routing
- Rewire the cymbal — move the internal red/black jumper from the Ride 1 input to the Ride 2 input (Support guide: "Rewire your Lemon 3-zone ride").
- Connect a ¼″ TRS cable from the cymbal's Ride 2 output to Input 10 RIDE on the rear panel.
- Connect a ¼″ TRS cable from the cymbal's Ride 1 output to Input 11 EDGE on the rear panel.
Module settings
- Press the [TRIGGER] button.
- Press the [F1] (BANK) button to open the TRIGGER BANK screen.
- Select the RIDE input (trigger input 10) (strike the pad or use the TRIG SELECT buttons).
- Use the [-] [+] buttons or the dial to set the trigger type to CY-15R (or CY-12R/C).
- Press the [F5] (ADVANCE) button to open the TRIGGER ADVANCED screen and set 3Way Trigger to ON.
Tips
- Both cables are required for full 3-zone operation (bell, bow, edge).
- If 3Way Trigger is OFF, the bell zone will not be detected separately.
- If the ride doesn't play at all, check that Ride 2 goes to Input 10 RIDE and Ride 1 to Input 11 EDGE.
- If the edge and bell sounds come out swapped, keep the cables where they are and follow the bell and edge section of the ride setup guide.
15" Triple-Zone Crash/Ride also fits 76 other drum modules — see setup
Other compatible drum modules
Alesis
Audiofront
Donner
Lekato
Millenium
Pearl
Roland
- Roland Octapad SPD-30
- Roland SPD-SX
- Roland SPD-SX PRO
- Roland TD-02
- Roland TD-07
- Roland TD-1
- Roland TD-4
- Roland TD-6
- Roland TD-8
- Roland TD-9
- Roland TD-10
- Roland TD-11
- Roland TD-12
- Roland TD-15
- Roland TD-17
- Roland TD-20
- Roland TD-25
- Roland TD-27
- Roland TD-50
- Roland TD-50X
- Roland V31
- Roland V51
- Roland V71