Free Shipping on All Orders
Lemon

Support

18" Triple-Zone Crash/Ride on Roland TD-30

Wiring, module settings, and tips for the 18" Triple-Zone Crash/Ride when used with the Roland TD-30.

Setup — 18" Triple-Zone Crash/Ride on Roland TD-30

Works

The 18" Triple-Zone Crash/Ride is fully supported on your Roland TD-30.

Bell Bow Edge

Wiring: 2× TRS → Input 11 RIDE + Input 12 RIDE EDGE on the rear panel

Full 3-zone ride using separate RIDE and RIDE EDGE inputs. 3Way Trigger must be set to ON.

Cable routing

  1. Connect a ¼″ TRS cable from the ride cymbal bow/bell output to Input 11 RIDE on the rear panel.
  2. Connect a ¼″ TRS cable from the ride cymbal edge output to Input 12 RIDE EDGE on the rear panel.

Module settings

  1. Press [TRIGGER] > [F1] BANK.
  2. Navigate to the RIDE input.
  3. Set the trigger type to CY-15R or CY-13R.
  4. Set 3Way Trigger to ON.

Tips

  1. Both cables are required for full 3-zone operation (bell, bow, edge).
  2. If 3Way Trigger is OFF, the bell zone will not be detected separately.
  3. Supports VH-12, VH-11, and VH-13 hi-hat types.