Support

15" Triple-Zone Crash/Ride on Alesis Nitro Ultimate

Wiring, module settings, and tips for the 15" Triple-Zone Crash/Ride when used with the Alesis Nitro Ultimate.

The 15" Triple-Zone Crash/Ride works on your Alesis Nitro Ultimate with reduced zones.

Bell Bow Edge

Wiring: 1× TRS (Cable 2) → RIDE connector on the cable snake — bow + bell

Full 3-zone is not supported — this module has a single Ride input. Connect Cable 2 (bow + bell) from the Lemon 3-zone ride cymbal; bow and bell zones both work through this cable.

Cable routing

Connect Cable 2 (the bow + bell cable) from the Lemon 3-zone ride cymbal to the RIDE input.

Module settings

Go to Utility → Trigger settings and select the RIDE input.
Assign the RIDE input as a 2-zone cymbal pad — the Nitro Ultimate shares the Nitro family trigger list and does not expose a 3-zone ride pad type.
Adjust SEN, THR, and CUR until bow and bell strikes register cleanly; dial sensitivity down one step if you get double-triggers from the bell region.
In your kit, load a ride-bow sample on the bow zone and a ride-bell sample on the second zone — bow and bell hits will play through Cable 2 as expected.

Tips

Cable 2 delivers bow and bell — the two most-used zones for ride playing.
Full simultaneous 3-zone operation is not available on this module — only one cable can be connected at a time.