Free Shipping on All Orders
Lemon

Support

15" Triple-Zone Crash/Ride on Roland TD-9

Wiring, module settings, and tips for the 15" Triple-Zone Crash/Ride when used with the Roland TD-9.

Setup — 15" Triple-Zone Crash/Ride on Roland TD-9

Works

The 15" Triple-Zone Crash/Ride is fully supported on your Roland TD-9.

Bell Bow Edge

Wiring: 2× TRS → RIDE + RIDE BELL connectors on the DB-25 cable snake

Full 3-zone ride with separate RIDE and RIDE BELL inputs via the cable snake.

Cable routing

  1. Connect a ¼″ TRS cable from the ride cymbal bow/edge output to the RIDE connector on the DB-25 cable snake.
  2. Connect a ¼″ TRS cable from the ride cymbal bell output to the RIDE BELL connector on the DB-25 cable snake.

Module settings

  1. Press [SETUP] > Trigger > Bank.
  2. Navigate to the RIDE input.
  3. Set the trigger type to match your ride cymbal.

Tips

  1. Both cables are required for full 3-zone operation (bell, bow, edge).
  2. If only one cable is connected, the ride will function as 2-zone only.