Free Shipping on All Orders
Lemon

Support

15" Triple-Zone Crash/Ride on Roland TD-02

Wiring, module settings, and tips for the 15" Triple-Zone Crash/Ride when used with the Roland TD-02.

Setup — 15" Triple-Zone Crash/Ride on Roland TD-02

Reduced — 2-zone ride

The 15" Triple-Zone Crash/Ride works on your Roland TD-02 with reduced zones.

Bell Bow Edge

Wiring: 1× TRS (Cable 2) → RIDE connector on the DB-25 cable snake — bow + bell

Full 3-zone is not supported — this module has a single Ride input. Connect Cable 2 (bow + bell) from the Lemon 3-zone ride cymbal; bow and bell zones both work through this cable.

Cable routing

  1. Connect Cable 2 (the bow + bell cable) from the Lemon 3-zone ride cymbal to the RIDE input.

Module settings

  1. Navigate to the RIDE input in the module setup menu (the TD-02 exposes only a small set of trigger parameters).
  2. The TD-02 does not expose a 3-zone ride pad type — the RIDE input will treat the cable as a 2-zone cymbal.
  3. Confirm the pad registers on strikes; adjust Sensitivity if bow/bell strikes read inconsistently.
  4. In your kit, load a ride-bow sample on the bow zone and a ride-bell sample on the second zone — bow and bell hits will play through Cable 2 as expected.

Tips

  1. Cable 2 delivers bow and bell — the two most-used zones for ride playing.
  2. Full simultaneous 3-zone operation is not available on this module — only one cable can be connected at a time.