Support
15" Triple-Zone Crash/Ride on Roland V31
Setup — 15" Triple-Zone Crash/Ride on Roland V31
WorksYes — the 15" Triple-Zone Crash/Ride works as a full 2-zone crash on the Roland V31: bow + edge.
Bow
Edge
Wiring: CRASH1 connector on the DB-25 cable snake → cymbal, or 1× TRS → the rear-panel TRIGGER IN (CRASH 2, AUX/TOM 4) jacks
Dual-zone crash triggering: bow (tip) and edge (ring) respond independently over the one lead. Choke works by grabbing the cymbal edge. The V-31 supports Roland CY-series 2-zone cymbals.
Crash setup and troubleshooting guide ›Cable routing
- Plug the CRASH1 connector on the DB-25 cable snake into the cymbal.
- For a second cymbal, connect a ¼″ TRS cable to the rear-panel TRIGGER IN CRASH 2 jack (p. 19–20) — 1/4-inch TRS (p. 226).
Module settings
- Press the [MENU] button.
- Use the cursor buttons to select "SYSTEM" -> "TRIGGER", then press [ENTER].
- Press the [F1] (BANK) button to open the TRIGGER - BANK screen.
- Select the CRASH1, CRASH2, or AUX/TOM4 input (strike the pad or use the cursor buttons).
- Use the dial to set the trigger type to the model that most closely matches your connected pad (the full trigger-type list is in the module's Data List).
- For finer control, press [F3] (BASIC) and adjust the pad's Sensitivity.
Tips
- Bow and edge zones respond independently.
- Choke works by grabbing the cymbal edge.
- The DIGITAL TRIGGER IN (USB) jack is for Roland digital pads only.
15" Triple-Zone Crash/Ride also fits 76 other drum modules — see setup
Other compatible drum modules
Alesis
Audiofront
Donner
Lekato
Millenium
Pearl
Roland
- Roland Octapad SPD-30
- Roland SPD-SX
- Roland SPD-SX PRO
- Roland TD-02
- Roland TD-07
- Roland TD-1
- Roland TD-4
- Roland TD-6
- Roland TD-8
- Roland TD-9
- Roland TD-10
- Roland TD-11
- Roland TD-12
- Roland TD-15
- Roland TD-17
- Roland TD-20
- Roland TD-25
- Roland TD-27
- Roland TD-30
- Roland TD-50
- Roland TD-50X
- Roland V51
- Roland V71