Support

15" Dual-Zone China on Roland V31

Wiring, module settings, and tips for the 15" Dual-Zone China when used with the Roland V31.

The 15" Dual-Zone China is fully supported on your Roland V31.

Bow Edge

Wiring: 1× TRS → CRASH1 connector on the DB-25 cable snake, or CRASH2 / AUX/TOM4 direct jack on the rear panel

Dual-zone crash triggering: bow (tip) and edge (ring) respond independently via the single TRS connection. Choke works by grabbing the cymbal edge. The V-31 supports Roland CY-series 2-zone cymbals.

Cable routing

Connect a ¼″ TRS cable from the cymbal to the CRASH1 connector on the DB-25 cable snake.
For additional cymbals, connect to the CRASH2 or AUX/TOM4 input on the rear panel.

Module settings

Press [TRIGGER] > [F1] BANK.
Navigate to the CRASH1, CRASH2, or AUX/TOM4 input.
Set the trigger type to CY-12C or CY-14C depending on your cymbal size.

Tips

Bow and edge zones respond independently.
Choke works by grabbing the cymbal edge.
The DIGITAL TRIGGER IN (USB) jack is for Roland digital pads only.