Official US store Free shipping Bundle & Save up to 20%
Lemon

Support

20" Triple-Zone Crash/Ride on Audiofront eDRUMin

Wiring, module settings, and tips for the 20" Triple-Zone Crash/Ride when used with the Audiofront eDRUMin.

Setup — 20" Triple-Zone Crash/Ride on Audiofront eDRUMin

Works

Yes — the 20" Triple-Zone Crash/Ride works as a full 3-zone ride on the Audiofront eDRUMin: bow + bell + edge.

Bell Bow Edge

Wiring: 2× TRS → two adjacent eDRUMin inputs (1/4" TRS jacks)

Set one input to Roland 3-Zone Ride (bow/edge) and the adjacent input auto-becomes bell. Also supports Bell Sense for single-input 3-zone on compatible pads.

Cable routing

  1. Connect the cymbal's Ride 1 output (bow/edge) to one eDRUMin input.
  2. Connect the cymbal's Ride 2 output (bow/bell) to the adjacent input — on the ED8/ED10 bow/edge goes to the top input and the bell to the bottom one; on the ED4, bow/edge left, bell right.
  3. Two separate 1/4" TRS cables are required for full 3-zone operation.
  4. Alternatively, single-cable 3-zone is possible via Bell Sense on compatible pads.

Module settings

  1. Open the eDRUMin Control Application > select the input > Trigger Editor.
  2. Set the Pad Type of the bow/edge input to 'Roland 3-Zone Ride' — the adjacent input automatically becomes the Bell input.
  3. Adjust Gain, Thresh, Scan, Hold, Decay, Bell Sense, Crosstalk, and the Velocity Curves.
  4. Use the Preset Manager for quick setup — eDRUMin ships factory presets for many commercially available pads.

Tips

  1. The eDRUMin manual lists the Lemon 18″ Ride among its supported pads.
  2. Bell Sense mode can detect bell hits from a single TRS cable on supported pads — leave THRESH at 75.
  3. The eDRUMin works with pads from any manufacturer.
  4. If the edge and bell sounds come out swapped, the two cables are reversed — swap them at the cymbal ends.
20" Triple-Zone Crash/Ride also fits 73 other drum modules — see setup

Other compatible drum modules

2Box

Alesis

ATV

Donner

Efnote

GEWA

NUX

Pearl

Roland

Simmons

Yamaha

Support contact

Have a question? Read the FAQ. Need manual help? Email support.