Support
20" Triple-Zone Crash/Ride on Yamaha DTX-PRO
Setup — 20" Triple-Zone Crash/Ride on Yamaha DTX-PRO
Use as 1-zone rideYes — the 20" Triple-Zone Crash/Ride works on the Yamaha DTX-PRO as a 1-zone ride: bow only.
Bell
Bow
Edge
Wiring: 1× TRS from the cymbal's Ride 2 output → Ride input — bow only
Full 3-zone is not supported — this module has a single Ride input, and it reads the Ride connection as a single-zone cymbal. Connect the cymbal's Ride 2 output (bow + bell); only bow-zone hits will trigger the kit’s ride voice.
Cable routing
- Connect the cymbal's Ride 2 output (bow + bell) to the Ride input.
Module settings
- Open the trigger-configuration menu on the DTX-PRO and select the Ride input (manual reference: [MENU] navigation).
- The DTX-PRO reads this wiring as a single-zone cymbal — bell triggering via the Ride 2 output is not officially supported at the pad-type level, so configure the input as a 1-zone / bow-only ride.
- Adjust Sensitivity, Threshold, and any available Crosstalk / Retrigger parameters per the DTX-PRO manual so bow strikes register cleanly.
- Load a ride patch whose bow sample works on its own — the module reads this wiring as single-zone, so bow hits are all you will hear through the Ride 2 output.
Tips
- The Ride 2 output still carries bow and bell from the cymbal, but this module only registers the bow zone.
- Full simultaneous 3-zone operation is not available on this module — only one cable can be connected at a time.
20" Triple-Zone Crash/Ride also fits 73 other drum modules — see setup
Other compatible drum modules
Alesis
Audiofront
Donner
Pearl
Roland
- Roland Octapad SPD-30
- Roland SPD-SX
- Roland SPD-SX PRO
- Roland TD-02
- Roland TD-07
- Roland TD-1
- Roland TD-4
- Roland TD-6
- Roland TD-8
- Roland TD-9
- Roland TD-10
- Roland TD-11
- Roland TD-12
- Roland TD-15
- Roland TD-17
- Roland TD-20
- Roland TD-25
- Roland TD-27
- Roland TD-30
- Roland TD-50
- Roland TD-50X
- Roland V31
- Roland V51
- Roland V71