Support

20" Triple-Zone Crash/Ride on Roland TD-11

Wiring, module settings, and tips for the 20" Triple-Zone Crash/Ride when used with the Roland TD-11.

Yes — the 20" Triple-Zone Crash/Ride works as a full 3-zone ride on the Roland TD-11: bow + bell + edge.

Bell Bow Edge

Wiring: 2× TRS → RIDE + RIDE BELL connectors on the DB-25 cable snake

Full 3-zone ride with separate RIDE and RIDE BELL inputs via the cable snake.

Connect a ¼″ TRS cable from the cymbal's Ride 1 output (bow/edge) to the RIDE connector on the DB-25 cable snake.
Connect a ¼″ TRS cable from the cymbal's Ride 2 output (bow/bell) to the RIDE BELL connector on the DB-25 cable snake.

In the DRUM KIT screen, press [MENU], scroll to the SYSTEM icon, and press [F3] (SYSTEM).
Use the cursor buttons to select "Pad Settings", press [F3] (ENTER), then press [F1] (TYPE).
Strike the ride to select the RIDE input, then set "Pad Type" to CY-13R or CY-15R to match your ride.
Press [F2] (BASIC) to fine-tune "Sensitivity" (1-32) and "Threshold" (0-31).

Both cables are required for full 3-zone operation (bell, bow, edge).
If only one cable is connected, the ride will function as 2-zone only.
If the edge and bell sounds come out swapped, the two cables are reversed — swap them at the cymbal ends.

20" Triple-Zone Crash/Ride also fits 73 other drum modules — see setup

Other compatible drum modules

Have a question? Read the FAQ. Need manual help? Email support.