Support
20" Triple-Zone Crash/Ride on Donner DED-400
Setup — 20" Triple-Zone Crash/Ride on Donner DED-400
Use as 2-zone rideYes — the 20" Triple-Zone Crash/Ride works on the Donner DED-400 as a 2-zone ride: bow + edge.
Bell
Bow
Edge
Plug: Ride 1
Wiring: RIDE lead on the signal-connection harness → Ride 1 (bow/edge)
Plug the Ride input into the Lemon ride's Ride 1 output for bow + edge — no cymbal modification. The DED-400 has no ride-bell voice, so bow + edge is the full 2-zone ride it can drive.
Ride setup and troubleshooting guide ›Cable routing
- Plug the RIDE lead on the module's signal-connection harness into the cymbal's Ride 1 output (bow/edge); the harness plugs into the module's TRIGGER INPUT port via its multi-pin parallel-port connector.
Module settings
- Press the MENU button, use +/- to select 2-PAD SET, and press OK to enter the pad parameter interface.
- Tap the ride pad to select it, then press + / - to choose a parameter and turn the encoder to set the value (press OK to confirm).
- Set Pad Sen (bow/surface sensitivity, 1-6), Rim Sen (edge sensitivity), Threshold (trigger threshold, 1-32), Xtalk (crosstalk threshold, 1-32), and Volume (0-127) so bow and edge hits register cleanly.
- Press SAVE to store the settings.
Tips
- This is the out-of-the-box setup — no cymbal modification.
- The DED-400's note tables list no ride-bell voice, so bow + edge is the full 2-zone ride this module can drive.
20" Triple-Zone Crash/Ride also fits 76 other drum modules — see setup
Other compatible drum modules
Alesis
Audiofront
Donner
Lekato
Millenium
Pearl
Roland
- Roland Octapad SPD-30
- Roland SPD-SX
- Roland SPD-SX PRO
- Roland TD-02
- Roland TD-07
- Roland TD-1
- Roland TD-4
- Roland TD-6
- Roland TD-8
- Roland TD-9
- Roland TD-10
- Roland TD-11
- Roland TD-12
- Roland TD-15
- Roland TD-17
- Roland TD-20
- Roland TD-25
- Roland TD-27
- Roland TD-30
- Roland TD-50
- Roland TD-50X
- Roland V31
- Roland V51
- Roland V71