Support
13" Triple-Zone Crash/Ride on Roland TD-9
Setup — 13" Triple-Zone Crash/Ride on Roland TD-9
WorksYes — the 13" Triple-Zone Crash/Ride works as a full 3-zone ride on the Roland TD-9: bow + bell + edge.
Bell
Bow
Edge
Wiring: “RD” + “RDB” leads on the DB-25 cable snake → Ride 1 + Ride 2
Full 3-zone ride with separate “RD” (ride) and “RDB” (ride bell) leads on the DB-25 cable snake.
Ride setup and troubleshooting guide ›Cable routing
- Plug the “RD” lead on the cable snake into the cymbal's Ride 1 output (bow/edge).
- Plug the “RDB” lead on the cable snake into the cymbal's Ride 2 output (bell).
Module settings
- Press [SETUP], then [F1] (TRIG), then [F1] (TYPE).
- Hit the ride to select the RIDE input (or use the CURSOR buttons).
- Set "Trig Type" to CY12RC or CY15R with [+/-] to match your ride.
- Press [F2] (BASIC) to fine-tune "Sensitivity" (1-32) and "Threshold" (0-31).
Tips
- Both leads are required for full 3-zone operation (bell, bow, edge).
- If only one lead is connected, the ride will function as 2-zone only.
- If the edge and bell sounds come out swapped, follow the bell and edge section of the ride setup guide.
13" Triple-Zone Crash/Ride also fits 76 other drum modules — see setup
Other compatible drum modules
Alesis
Audiofront
Donner
Lekato
Millenium
Pearl
Roland
- Roland Octapad SPD-30
- Roland SPD-SX
- Roland SPD-SX PRO
- Roland TD-02
- Roland TD-07
- Roland TD-1
- Roland TD-4
- Roland TD-6
- Roland TD-8
- Roland TD-10
- Roland TD-11
- Roland TD-12
- Roland TD-15
- Roland TD-17
- Roland TD-20
- Roland TD-25
- Roland TD-27
- Roland TD-30
- Roland TD-50
- Roland TD-50X
- Roland V31
- Roland V51
- Roland V71