Support
20" Triple-Zone Crash/Ride on Alesis DM10 MKII
Setup — 20" Triple-Zone Crash/Ride on Alesis DM10 MKII
WorksYes — the 20" Triple-Zone Crash/Ride works as a full 2-zone crash on the Alesis DM10 MKII: bow + edge.
Bow
Edge
Wiring: 1× TRS → Crash 1 on the DB-25 cable snake, or the rear-panel Crash 2 Trigger Input
A DB-25 cable snake plus two rear-panel ¼″ TRS trigger inputs, Crash 2 and Tom 4. Updated DM10 platform. Bow and edge read independently over one TRS cable; the edge zone is tuned with Rim Sens.
Cable routing
- Connect a ¼″ TRS cable from the cymbal to the Crash 1 connector on the DB-25 cable snake, or to the Crash 2 Trigger Input on the rear panel (¼″ TRS) — either reads bow and edge.
Module settings
- Press Trigger to enter the trigger interface page, then hit the Crash pad to select it.
- Adjust Head Sensitivity, Rim Sens, and Threshold to taste.
- Press F3-Save to keep the settings — otherwise they are lost when you power off the module.
Tips
- Set Rim Sens to tune the edge-zone response.
- The DM10 MKII retains the same trigger architecture as the original DM10.
20" Triple-Zone Crash/Ride also fits 74 other drum modules — see setup
Other compatible drum modules
Alesis
Audiofront
Donner
Pearl
Roland
- Roland Octapad SPD-30
- Roland SPD-SX
- Roland SPD-SX PRO
- Roland TD-02
- Roland TD-07
- Roland TD-1
- Roland TD-4
- Roland TD-6
- Roland TD-8
- Roland TD-9
- Roland TD-10
- Roland TD-11
- Roland TD-12
- Roland TD-15
- Roland TD-17
- Roland TD-20
- Roland TD-25
- Roland TD-27
- Roland TD-30
- Roland TD-50
- Roland TD-50X
- Roland V31
- Roland V51
- Roland V71