Support
18" Triple-Zone Crash/Ride on Roland TD-1
Setup — 18" Triple-Zone Crash/Ride on Roland TD-1
WorksYes — the 18" Triple-Zone Crash/Ride works as a full 2-zone crash on the Roland TD-1: bow + edge.
Bow
Edge
Wiring: The crash lead on the dedicated connection cable → cymbal
Dual-zone crash triggering: bow (tip) and edge (ring) respond independently over the one lead. Choke works by grabbing the cymbal edge. The TD-1 addresses two 2-zone crash triggers, CR1 and CR2, each with its own bow and edge note.
Crash setup and troubleshooting guide ›Cable routing
- Plug the included dedicated connection cable's crash lead into the Lemon crash. Its other end goes to the module's single TRIGGER INPUT connector — each lead is labeled for its pad, and the manual's instruction is simply to "connect the appropriately labeled cable to each pad".
Module settings
- Press the [Select] button to select Drums mode, then long-press the [Metronome] button so the mode lamp blinks (Making Detailed Settings).
- Press the [Select] button to blink the Drums mode lamp (Adjust the Pad Sensitivity).
- Play the cymbal, then use the [-] [+] buttons to adjust its sensitivity.
- Press the [Metronome] button to complete the setting.
Tips
- Bow and edge zones respond independently.
- Choke works by grabbing the cymbal edge.
18" Triple-Zone Crash/Ride also fits 76 other drum modules — see setup
Other compatible drum modules
Alesis
Audiofront
Donner
Lekato
Millenium
Pearl
Roland
- Roland Octapad SPD-30
- Roland SPD-SX
- Roland SPD-SX PRO
- Roland TD-02
- Roland TD-07
- Roland TD-4
- Roland TD-6
- Roland TD-8
- Roland TD-9
- Roland TD-10
- Roland TD-11
- Roland TD-12
- Roland TD-15
- Roland TD-17
- Roland TD-20
- Roland TD-25
- Roland TD-27
- Roland TD-30
- Roland TD-50
- Roland TD-50X
- Roland V31
- Roland V51
- Roland V71