Free Shipping on All Orders
Lemon

Support

18" Triple-Zone Crash/Ride on Efnote 7

Wiring, module settings, and tips for the 18" Triple-Zone Crash/Ride when used with the Efnote 7.

Setup — 18" Triple-Zone Crash/Ride on Efnote 7

Reduced — 2-zone ride

The 18" Triple-Zone Crash/Ride works on your Efnote 7 with reduced zones.

Bell Bow Edge

Wiring: 1× TRS (Cable 2) → Ride input — bow + bell

Full 3-zone is not supported — this module has a single Ride input. Connect Cable 2 (bow + bell) from the Lemon 3-zone ride cymbal; bow and bell zones both work through this cable.

Cable routing

  1. Connect Cable 2 (the bow + bell cable) from the Lemon 3-zone ride cymbal to the Ride input.

Module settings

  1. Open the Ride input’s trigger-parameters page on the module.
  2. The EFNOTE 7 ships a single Ride input and does not expose a 3-zone ride pad type in this configuration — the input reads Cable 2 as a dual-zone cymbal.
  3. Adjust Sensitivity, Threshold, Crosstalk, and Retrigger until bow and bell strikes register cleanly.
  4. In your kit, load a ride-bow sample on the bow zone and a ride-bell sample on the second zone — bow and bell hits will play through Cable 2 as expected.

Tips

  1. Cable 2 delivers bow and bell — the two most-used zones for ride playing.
  2. Full simultaneous 3-zone operation is not available on this module — only one cable can be connected at a time.